![]() Since it is new, I would call in their field tech to resolve this. ![]() It sounds like your AHC Automatic Height Control is out of adjustment or not working. (we were changing our tip frequently) Any Ideas or experienced wisdom on anyone's part would be greatly appreciated. We have found that putting the ground clamp directly on one corner of the sheet we are cutting seemed to help but it is not the solution. more amperage.or less amperage.check your ground. Some phone calls placed to the fellow who was supposed to know turns into. nobody seems to be able to tell us what to try or what might be causing this. 18, 20-26 ga the tip seems to dive into the material frequently and causes much down time and lots of frustration for the operator. ![]() We have a plasma table (I believe they call it a high definition? It seems to cut the black and stainless fairly well but the galvanized material is giving us grief.especially in the smaller sizes. We also do quite a bit of sheet metal work with galvanized in various gauge sizes. We are in the set up phase and are set up with equipment to do 1/4" and under as well as stainless steel, hot rolled, cold rolled and aluminum. Hi everyone, I am in the front office (Inside Sales) of a fairly large fabrication shop. Plating, anodizing, & finishing Q&As since 1989
0 Comments
Leave a Reply. |